Feeding
6–40 V
Output interface
CAN 11-bit/29-bit
CAN Reader Light BITREK
The CAN Reader Light BITREK device is designed to read data from the CAN bus without damaging the insulation of the vehicle’s wires. It eliminates any influence on the vehicle’s standard electronics, ensuring stable data reading. New housing-free version for easy installation in difficult locations.
CAN Reader Light BITREK
Key features
The CAN Reader Bitrek is designed for contactless reading of data from the CAN bus of a vehicle and formation of an output signal identical to the read one. In this case, the connection is made without direct insertion into the wires of the CAN bus signal lines, without violating the integrity of the insulation of the vehicle's electrical wires. The principle of operation of the CAN Reader Bitrek is based on reading the electromagnetic field that is formed around the wire when the signal passes, with subsequent data transmission to the tracker.
Main features
- Reading CAN data without direct connection
- Ability to work with buses of different speeds
- Support CAN 11-bit/29-bit
- Easy installation
Applying
// This model is ideal for
Agricultural machinery
Construction and special equipment
Monitoring of buses and passenger transport
Characteristics
Power supply type and voltage
constant, 6–40 V
Typical consumption current
20 mA
Output interface
CAN 11-bit/29-bit
Operating temperature
from -30 °C to +80 °C
Relative humidity
5–95% non-condensing
Overall dimensions
90 х 20 х 5 mm
Net weight
20 g
Protocols and Integration (For Developers)
-
Supported data transfer interfacesCAN 11-bit/29-bit
-
Configurationno setup required
-
Full compatibilitywith devices with CAN interface
// FAQ
Questions and answers
Can I use a contactless reader to connect a tachograph?
Since two-way data exchange is performed between the tracker and the tachograph, the use of a contactless reader is not possible in this case.
Is it possible to connect two contactless readers to a tracker with one CAN interface to receive data from two buses simultaneously?
With such a configuration, two readers will conflict with each other, therefore, one reader is always connected to one CAN interface.
Do I need to configure the reader?
CAN Reader Light BITREK does not require configuration.
